1 Introduction

Megaco/H.248 is a protocol for control of elements in a physically decomposed multimedia gateway, enabling separation of call control from media conversion. A Media Gateway Controller (MGC) controls one or more Media Gateways (MG).

This version of the stack supports version 1, 2 and 3 as defined by:

• version 1 - RFC 3525 and H.248-IG (v10-v13)

• version 2 - draft-ietf-megaco-h248v2-04 & H.248.1 v2 Corrigendum 1 (03/2004)

• version 3:

  • prev3a - as defined by TD-33 (except segments)

  • prev3b - TD-33 updated to be backward compatible with v2 (except segments)

  • prev3c - As defined by ITU H.248.1 (09/2005) (except segments)

  • v3 - Full version 3 as defined by ITU H.248.1 (09/2005) (including segments)

The semantics of the protocol has jointly been defined by two standardization bodies:

• IETF - which calls the protocol Megaco

• ITU - which calls the protocol H.248

1.1 Scope and Purpose

This manual describes the Megaco application, as a component of the Erlang/Open Telecom Platform development environment. It is assumed that the reader is familiar with the Erlang Development Environment, which is described in a separate User's Guide.

1.2 Prerequisites

The following prerequisites is required for understanding the material in the Megaco User's Guide:

• the basics of the Megaco/H.248 protocol

• the basics of the Abstract Syntax Notation One (ASN.1)

• familiarity with the Erlang system and Erlang programming

The application requires Erlang/OTP release R10B or later.

1.3 About This Manual

In addition to this introductory chapter, the Megaco User's Guide contains the following chapters:

• Chapter 2: "Architecture" describes the architecture and typical usage of the application.

• Chapter 3: "Internal form and its encodings" describes the internal form of Megaco/H.248 messages and its various encodings.

• Chapter 4: "Transport mechanisms" describes how different mechanisms can be used to transport the Megaco/H.248 messages.

• Chapter 5: "Debugging" describes tracing and debugging.

1.4 Where to Find More Information

Refer to the following documentation for more information about Megaco/H.248 and about the Erlang/OTP development system:

• version 1, RFC 3525

• old version 1, RFC 3015

• Version 2 Corrigendum 1

• version 2, draft-ietf-megaco-h248v2-04

• TD-33 (Draft H.248.1 version 3)

• H.248.1 version 3

• the ASN.1 application User's Guide

• the Megaco application Reference Manual

• Concurrent Programming in Erlang, 2nd Edition (1996), Prentice-Hall, ISBN 0-13-508301-X.